Instruction Manual

Configuration
Sealevel Systems SeaPORT+4/485 Page 4
Configuration
Original configuration
This device ships from Sealevel Systems with the following configuration.
422 mode,
120 ohm termination,
1K ohm pull up on RX+
1K ohm pull down on RX-
In order to change this configuration the box must be opened. Do this by
removing the four screws located on the bottom. When reassembling please note
that the top and bottom are keyed to fit in only one direction.
Electrical Interface Selection
Each of the four ports on the SeaPORT+4/485 can be individually configured
as an RS-232, RS-422, or RS-485 interface. This is selectable via the DIP
switches and DIP shunts. Each of the switch positions is described on the
following page.