Use and Care Manual
11 - ENG
Outlet
Regulator
The air pressure coming from the air
tank is controlled by the regulator.
To increase the pressure, turn the knob
clockwise,and to decrease the
pressure, turn the knob counter-
clockwise.
Indicates the reserve air
pressure in the tank.
Indicates the outgoing air pressure
to the tool and is controlled by the
regulator.
Offers a quick release feature for
attaching and removing the air hose.
When the pump is not in operation
the valve closes to retain air
pressure inside the tank.
An internal component.
This controls the power to the
motor and also the cut-in/
cut-out pressure settings.
This switch serves as the
Auto-On/Off positions for the unit.
Used to allow excess tank
pressure to escape into the
atmosphere. This valve should only
open when the tank pressure is
above the maximum rated pressure.
Used to drain condensation from the air
tank. Located at bottom of tank.
Provides clean air to the pump and
must always be kept free of debris.
Check on a daily basis or before
each use.