Use and Care Manual

14 200-2381
Ensure that all guards and shrouds are in
place before pressing the reset switch to restart the
motor.
If the motor shuts down because of overload, wait 10–15
minutes so the motor can cool down, then press (NEVER force)
the reset switch (see A) to restart the motor (see Fig. 5).
Note: On stationary models not supplied with a power cord,
the electrical power must be wired into the pressure
switch by a Licensed Electrician.
Veillez à ce que toutes les
sécurités et protections soient installées avant d’appuyer
sur l’interrupteur de remise en marche.
Si le moteur s’arrête à cause d’une surcharge, attendez
10 à 15 minutes que le moteur ait refroidi, puis appuyez SANS
FORCER sur l’interrupteur de remise en marche du moteur (A)
pour le redémarrer (Fig. 5).
REMARQUE : Sur les modèles stationnaires non fournis avec
un cordon de secteur, le courant électrique doit être
câblé dans le mano-contact par un électricien
autorisé.
Asegúrese de que todos los
protectores y cubiertas estén colocados en su lugar antes
de presionar el interruptor de restablecimiento para volver
a arrancar el motor.
Si el motor se apaga debido a una sobrecarga,
espere entre 10 y 15 minutos para que el motor pueda
enfriarse y luego presione (NUNCA fuerce) el interruptor de
restablecimiento (vea A) para volver a arrancar el motor (Fig.
5).
Nota: En los modelos inmóviles no provistos de un cable
eléctrico, la corriente eléctrica se debe atar con
alambre en el interruptor de presión por un electricista
licenciado.
WARNING:
A
AVERTISSEMENT:
ADVERTENCIA:
MOTOR RESET AND WIRING \ REMISE EN MARCHE ET CÂBLAGE DU MOTEUR \
RESTABLECIMIENTO Y CABLEADO DEL MOTOR
MOTOR RESET SWITCH
INTERRUPTEUR DE REMISE EN
MARCHE DU MOTEUR
INTERRUPTOR DE
RESTABLECIMIENTO DEL MOTOR
Fig. 5