Data Sheet

Page
20
TOP ZONE.
NOTE: Although in the TOP ZONE serigraphy it is shown Q0.9 & Q0.8 pins, in the reality they
are I0.3 I0.2 pins respectively. Additionally although the serigraphy only is expressed for the
RS485 it is also the same for the RS232. So if it is desired to enable any of the Hardware Serial
connection this is the function of these switches. See chapter 8 for more information
1. I0.3: If this switch is ON, the RS485/RS232 HS switch must be set to OFF. Being in ON
mode it enables I0.3.
2. RS485/RS232 HS: If this switch is ON, the I0.3 switch must be set to OFF. Being in ON
mode it enables the D0 for the RS-485 or RS-232 Hardware Serial (see section 9 for
jumper configuration)
3. I0.2: If this switch is ON, the RS485 switch must be set to OFF. Being in ON mode it
enables I0.2.
4. RS485/RS232 HS: If this switch is ON, the I0.2 switch must be set to OFF. Being in ON
mode it enables the D1 for the RS485 or RS-232 Hardware Serial (see section 9 for
jumper configuration)
RIGHT ZONE
RIGHT ZONE. The right zone configures the outputs. If the switch is set to “ON” the Q0.X will
have the behaviour of a digital output. If it is set to “OFF” it will be analog. There is also a switch
for switching between Half and Full Duplex. It is “ON” for Half Duplex and “OFF” for Full Duplex.
TOP ZONE
SWITCH
OFF
ON
I0.3
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.2
RS485/RS232 HS
I0.3
RS485/RS232 HS
I0.2
RS485/RS232 HS
RIGHT ZONE
SWITCH
OFF
ON
H/F
Full Duplex
Half Duplex
Q0.6
ANALOG (A0.6)
DIGITAL (Q0.6)
Q0.5
ANALOG (A0.5)
DIGITAL (Q0.5)
Q0.4
ANALOG (A0.4)
DIGITAL (Q0.4)
Q0.3
ANALOG (A0.3)
DIGITAL (Q0.3)
Q0.2
ANALOG (A0.2)
DIGITAL (Q0.2)
Q0.1
ANALOG (A0.1)
DIGITAL (Q0.1)
Q0.0
ANALOG (A0.0)
DIGITAL (Q0.0)