Operation Manual

customers and gate openers” later in
this section.
JVI0429X
3. Press and hold the programmed
HomeLink
®
button and observe the
indicator light.
.
If the indicator light
*
1
is solid/
continuous, programming is com-
plete and your device should acti-
vate when the HomeLink
®
button is
pressed and released.
.
If the indicator light
*
1
blinks
rapidly for two seconds and then
turns to a solid/continuous light,
continue with Steps 4-6 for a rolling
code device. A second person may
make the following steps easier. Use
a ladder or other device. Do not
stand on your vehicle to perform the
next steps.
4. At the receiver located on the garage
door opener motor in the garage, locate
the “learn” or “smart” button (the
name and color of the button may vary
by manufacturer but it is usually
located near where the hanging anten-
na wire is attached to the unit). If there
is difficulty locating the button, refer-
ence the garage door opener’s manual.
5. Press and release the “learn” or
“smart” button.
NOTE:
Once the button is pressed, you have
approximately 30 seconds to initiate
the next step.
6. Return to the vehicle and firmly press
and hold the programmed HomeLink
®
button for two seconds and release.
Repeat the “press/hold/release” se-
quence up to 3 times to complete the
programming process. HomeLink
®
should now activate your rolling code
equipped device.
7. If you have any questions or are having
difficulty programming your
HomeLink
®
buttons, refer to the
Instruments and controls 2-63