Operation Manual

5-38 Starting and driving
How to enable/disable the BSI
system using the settings menu
Perform the following steps to enable or
disable the BSI system.
1. Push the SETTING
*
1
button and high-
light the “Driver Assistance” key on the
display using the INFINITI controller.
Then push the ENTER
*
2
button.
2. Highlight the “Dynamic Assistance Set-
tings” key, and push the ENTER
*
2
button.
SSD1002
3. Highlight the “Blind Spot Intervention”
key, select ON (enabled) or OFF (dis-
abled) and push the ENTER
*
2
button.
For the LDP and DCA systems, see “Lane
Departure Prevention (LDP) system” earlier
in this section and “Distance Control Assist
(DCA) system” later in this section.
WARNING
. Do not use the BSI system under the
following conditions because the system
may not function properly.
— During bad weather (for example,
rain, fog, snow, wind, etc.)
— When driving on slippery roads,
such as on ice or snow, etc.
— When driving on winding or uneven
roads.
— When there is a lane closure due to
road repairs.
— When driving in a makeshift lane.
— When driving on roads where the
lane width is too narrow.
— When driving with a tire that is not
within normal tire conditions (for
example, tire wear, low tire pressure,
installation of spare tire, tire chains,
non-standard wheels).
— When the vehicle is equipped with
non-original brake parts or suspen-
sion parts.
. Excessive noise (for example, audio
system volume, open vehicle window)
will interfere with the chime sound, and
it may not be heard.
. The radar sensors may not be able to
detect and activate BSI/BSW when
certain objects are present such as: