User's Manual

!
Important Safety Instructions
1. Carefully read all of the instructions provided and save them for later use. Read all
warnings and instructions marked on the BR-1001.
2. Do not place the BR-1001 on an unstable stand or surface as it may fall resulting in
serious damage.
3. The radar antenna should be handled with great care at all time to avoid damaging the
antenna radome. Radome damage can result in performance reduction.
4. The BR-1001 must be operated from a 115Vac 60Hz power source for the North
America model, or from a 230Vac 50Hz power source for the European model. The
equipment is factory set for either 115Vac or 230Vac, as marked on the equipment.
Ensure that the supply voltage available at the installation site meets the factory set
voltage range marking, as provided on the equipment.
5. The BR-1001 power cord is equipped with a three-prong grounding plug that will
only fit into a grounding type power outlet. This is a safety feature. If you are unable
to insert the plug into the outlet, contact a qualified person to replace the obsolete
outlet. Do not tamper with the grounding prong to force fit into the outlet.
6. Do not allow any objects to rest on the power cord or place the BR-1001 where the
power cord will be trampled on.
7. If an extension cord is used with the BR-1001, make sure that the total ampere ratings
of the devices plugged into the extension cord do not exceed the extension cord
ampere rating.
8. Do NOT plug in, turn on or attempt to operate an obviously damaged unit.
9.
Warning: No operator serviceable parts inside the BR-1001 radar unit. Please refer
servicing to service qualified personnel.
Rev. 02
1