user manual

EonStor A12U/A08U-G2421 Installation and Hardware Reference Manual

Warnings and Certifications

FCC (applies in the U.S. and Canada)

FCC Class B Radio Frequency Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules (47 CFR, Part 2, Part 15 and

CISPR PUB. 22 Class B). These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy

and, if not installed and used in accordance with this user’s guide, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help

This device complies with Part 15 of FCC Rules. Operation is subjected to the

following two conditions: 1) this device may not cause harmful interference, and 2)

this device must accept any interference received, including interference that may

cause undesired operation.

Warning:

A shielded power cord is required in order to meet FCC emission limits and also to

prevent interference to nearby radio and television reception.

Use only shielded cables to connect I/O devices to this equipment. You are cautioned

that changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.

This device is in conformity with the EMC.

(Certified Worldwide)

This device meets the requirements of the CB standard for electrical equipment with regard to

establishing a satisfactory level of safety for persons using the device and for the area

surrounding the apparatus. This standard covers only safety aspects of the above apparatus; it

does not cover other matters, such as style or performance.