ELD Series Installation Manual

Electric I&O Manual IM111116 RL:1 Nov 2016
5
REPLACEMENT ELEMENT INSTALLATION
11/32" OUTSIDE NUT
11/32" INSIDE NUT [SNUG TO CERAMIC]
Disconnect the power at the breaker. Remove the grill by grasping it in the middle, ex grill up and lift it off.
Unscrew and remove both end reectors. Unhook element clips at each end of the heater and remove nuts from
end of element to remove the existing Quartz. Carefully install the new element. Remove one nut from end of the
new element. Install wire by sliding high temperature ring terminal onto element screw and replace nut. Use a thin
11/32" wrench to hold inside nut. Nuts must make a tight connection. Close element clips over tube, reinstall end
reectors, then snap protective grill back in place.
NOTE: Hold ceramic element rmly while
tightening nut to prevent damage to element.
Nut should be tightened snug. A loose
connection can cause the element to short or fail
prematurely.
Consult the
label on back of
heater for proper
watts, voltage,
and replacement
element part
number.
Need help?
To order
replacement
elements for your
heating system,
please contact us
via phone or visit
our website.
REPLACEMENT ELEMENTS [OTHER VOLTAGES ALSO AVAILABLE]
PART NUMBER LENGTH WATTS VOLTS FITS
JE-0550-12 16.5" [0.4 m] 500 120 ES-0519-12, EL-0519-12
JE-0551-12 16.5" [0.4 m] 750 120 ES-0719-12, EL-0719-12
JE-0552-12 30" [0.8 m] 1000 120 ES-1033-12, EL-1033-12
JE-0553-12 30" [0.8 m] 1500 120 ES-1533-12, EL-1533-12
JE-0554-20 16-1/2" [0.4 m] 2000 208 ES-2039-20, ES-4039-20/EL-2039-20, EL-4039-20
JE-0555-20 30" [0.8 m] 2500 208 ES-2539-20, ES-5039-20/EL-2539-20, EL-5039-20
JE-0556-20 30" [0.8 m] 3000 208 ES-3061-20, ES-6061-20/EL-3061-20, EL-6061-20
JE-0557-20 36" [0.9 m] 4000 208 ES-4061-20/EL-4061-20
JE-0554-24 36" [0.9 m] 2000 240 ES-2039-24, ES-4039-24/EL-2039-24, EL-4039-24
JE-0555-24 58" [1.5 m] 2500 240 ES-2539-24, ES-5039-24/EL-2539-24, EL-5039-24
JE-0556-24 58" [1.5 m] 3000 240 ES-3061-24, ES-6061-24/EL-3061-24, EL-6061-24
JE-0557-24 58" [1.5 m] 4000 240 ES-4061-24/EL-4061-24
REPLACEMENT PARTS
PART NUMBER PART DESCRIPTION QUANTITY
JE-0570-XX Single Element End Reector [Set of 2] 1
JE-0571-XX Dual Element End Reector [Set of 2] 1
JE-0573-XX, JE-0574-XX, JE-0575-XX Body Reector – Fits 33" [0.8 m], 39" [1.0 m], 61-1/4" [1.6 m] 1
JE-0577-XX, JE-0578-XX, JE-0579-XX Grill Guard – Fits 33" [0.8 m], 39" [1.0 m], 61-1/4" [1.6 m] 1
JE-0581-XX, JE-0582-XX, JE-0583-XX Lead Wire Set – Fits 33" [0.8 m], 39" [1.0 m], 61-1/4" [1.6 m]* 1
JE-0585-XX Stainless Steel Mounting Bracket [Set of 2] 1
* Note: Dual Element Heaters require 2 Lead Wire Sets per Heater