User's Manual
Table Of Contents
- Contents
- 1 Overview
- 2 DC and AC Characteristics
- 3 Electrical Interface
- 4 SPI Interface and Sequences
- 5 Power States
- 6 Messaging Protocol
- 7 microNode Provisioning
- 8 Antenna Diversity
- 9 Regulatory Considerations
- 10 Manufacturing Considerations
- 11 Errata
- Appendix A Abbreviations and Terms
- Appendix B PCB Land Pattern and Vias
- Appendix C REACH AND RoHS Compliance
- Appendix D On-Ramp Wireless RMA Process
- Appendix E microNode Mechanical Drawing
microNode Integration Specification Regulatory Considerations
On-Ramp Wireless, Inc. 43 014-0033-00 Rev. H
B unintentional radiator and powerline conducted emissions tests. This should be done with
the actual production antenna.
ETSI
Europe’s system is a self-declaration system. There are no documents to submit or
certification grants to obtain. One must have the passing test results available for all
applicable requirements at any time if challenged.
Other countries will vary.
9.4 FCC Warnings
This device complies with part 15 of the Federal Communications Commission (FCC) Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
WARNING:
This equipment generates, uses, and can radiate radio frequency energy. If not
installed and used in accordance with the instructions, this equipment may cause
harmful interference to radio communications. However, there is no guarantee
that inter
ference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference
by one or more of the following measures:
Re-orient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
9.5 IC Warnings
The installer of this radio equipment must ensure that the antenna is located or pointed so that
it does not emit RF field in excess of Health Canada limits for the general population. Consult
Safety Code 6 which is obtainable from Health Canada’s website http://www.hc-sc.gc.ca/index-
eng.php.