User's Manual

microNode Integration Specification Regulatory Considerations
On-Ramp Wireless, Inc. 44 014-0033-00 Rev. H
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
To reduce potential radio interference to other users, select the antenna type and its gain so
that the equivalent isotropically radiated power (EIRP) is not more than that permitted for
successful communication.
Canadian Two Part Warning Statement:
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
9.6 ETSI Warnings
None known.
9.7 Usage
This device is only authorized for use in fixed and mobile applications. To meet FCC and other
national radio frequency (RF) exposure requirements, the antenna for this device must be
installed to ensure a separation distance of at least 20cm (8 inches) from the antenna to a
person.
Table 10. RF Certification IDs
microNode Version RF Certification ID
microNode1 FCC ID: XTE-ULPU100
IC ID: 8655A-ULPU100
microNode2 FCC ID: XTE-NODE102
IC ID: 8655A-NODE102
9.7.1 Product Labels
If the microNode is visible in a product, the label showing the FCC ID and IC designators (listed
above) must be visible from the exterior of the product. A representative label is shown below.