User's Manual

microNode Integration Specification Regulatory Considerations
On-Ramp Wireless, Inc. 45 014-0033-00 Rev. H
Figure 23. Product Label
If the microNode is contained within a product and is not visible, a label showing the FCC ID and
IC designators (listed above) must be affixed to the exterior of the device containing the
microNode. The exterior label must state the following:
Table 11. Label Statements
microNode Version RF Certification ID
microNode1 Contains FCC ID: XTE-ULPU100, IC: 8655A-ULPU100
microNode2 Contains FCC ID: XTE-NODE102, IC: 8655A-NODE102
9.7.2 RF Exposure Statement
The air interface supports operation on channels in the 2402 MHz – 2476 MHz range for FCC/IC
regulatory domains and 2402 MHz – 2481 MHz for the ETSI regulatory domain.
Before the microNode becomes operational, it must undergo a commissioning procedure,
during which critical information required for operation is entered into the device and stored in
non-volatile storage. It is during the initial commissioning procedure that the regulatory domain,
under which the device will operate, is set. Subsequent configuration of the device during
operation is checked against the commissioned regulatory domain and non-permitted channels
or transmit power levels are rejected and the device will not transmit until a permissible
configuration per the commissioned regulatory domain is set.
9.8 WEEE Directive
The WEEE directives do not apply to microNodes as they are not considered “end products” that
would put them under the WEEE initiatives in the EU.
9.9 REACH Directive
The microNodes are REACH compliant under 1907/2006/EC. This certification is located in
Appendix C.