Manual

Determineflatnessbyplacingthestraightedgeofaruler
acrossthebottomofthecookware.Whileyourotatetheruler,
nospaceorlightshouldbevisiblebetweenit andthe
cookware.
• Cookwaredesignedwithslightlyindentedbottomsorsmall
expansionchannelscanbeused.
• Makesurethebottomsofpotsandpansarecleananddry
beforeusingthem.Residueandwatercanleavedeposits
whenheated.
• Donotcookfoodsdirectlyonthecooktop.
Hot Surface Indicator Light (under ceramic glass)
The hot surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area(s) is turned off.
To Replace:
1. Lineup openings in the burner bowl withthe coil element
receptacle.
\
2. Holding the coil element as level as possible, slowly push coil
element terminal into the receptacle.
3. When the terminal is pushed into the receptacle as far as it
will go, push down the edge of the coil element opposite the
receptacle.
Coil elements should be level for optimal cooking results. Burner
bowls, when clean, reflect heat back to the cookware. They also
help catch spills.
Cookware should not extend more than 1" (2.5 cm) over the coil
element. If cookware is uneven or too large, it can produce
excess heat causing the burner bowl to change color. For more
information, see the "General Cleaning" section.
NOTE: Before removing or replacing coil elements and burner
bowls, make sure they are cool and the control knobs are in the
Off position.
To Remove:
1. Push in the edge of coil element toward the receptacle. Then
lift it just enough to clear the burner bowl.
The lift-up cooktop provides easy access for cleaning beneath.
Do not drop the cooktop. Damage could occur to the finish and
the cooktop frame. For more information, see the "General
Cleaning" section.
To Lift:
Lift the cooktop by beth front corners until the supports lock into
place.
2=
Pull the coil element straight away from the receptacle.
3. Lift out the burner bowl.
To Replace:
1. Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2. Slowly lower the cooktop into place.
When canning for long periods, alternate the use of surface
cooking areas, elements or surface burners between batches.
This allows time for the most recently used areas to cool.
• Center the canner on the grate or largest surface cooking
area or element. Canners should not extend more than
1" (2.5 cm) outside the cooking area.
• Do not place canner on 2 surface cooking areas, elements or
surface burners at the same time.
• On ceramic glass models, use only flat-bottomed canners.
On coil element models, the installation of a Canning Unit Kit
is recommended. If a kit is not installed, the life of the coil
element will be shortened. See "Assistance or Service" for
ordering instructions.
• For more information, contact Agriculture Canada.
Companies that manufacture home canning products can
also offer assistance.