Installation Manual

InnoSenT sets standards – worldwide
Page 4 Version 1.0 USER MANUAL IPM-224_F
InnoSenT GmbH
Am Rödertor 30
97499 Donnersdorf
GERMANY
Contact Informaon
InnoSenT GmbH | Am Roedertor 30 | 97499 Donnersdorf | Germany
Phone: [phone] | Fax: [phone] | E-Mail: [e-mail]
www.innosent.de
Approval
FCC approval
Labeling
This Data Sheet contains the technical specicaons of the described product. Changes of the
specicaon must be in wrien form. All previous versions of this Data Sheet are no longer valid.
The technical specicaons of this Data Sheet are approved by:
The adhesive label on the cover of the sensor provides the following informaon:
FCC/IC-ID
serial number
version (K01 / K02)
last 3digits of the tramsmit frequency
(e.g. 24.125GHz = 125)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operaon is subject to the following two condions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operaon.
Warning: Changes or modicaons made to this equipment not expressly approved by InnoSenT
GmbH may void the FCC authorizaon to operate this equipment.
Manufacturers of mobile or xed devices incorporang IPM-224_F modules are authorized to use
the FCC Grants and IC Cercates of the IPM-224_F modules for their own nal products according
to the condions referenced in these documents. In this case, the FCC label of the module shall be
visible from the outside, or the host device shall bear a second label stang contains FCC ID: UXS-
IPM224F and contains IC: 6902A-IPM224F.
model number