Manual

© Mass Electronics Pty Ltd 2007
Page 9
Technical Manual Overview
The Installation Manual for Innotech Device Network Cabling is part of a series of technical manuals
designed to provide the customer with complete and comprehensive documentation supporting the
Innotech Digital Control system. It contains detailed information for the primary network and the two
sub networks.
• Network Connections
• Earth connection rules
• End Of Line Termination
• Descriptions on dierent comms hardware improvements
About this Manual
This instruction manual is intended to provide the user with complete and easy-to-follow instructions
for installation of Innotech Communication networks. In preparing these instructions, Innotech
assumed that the installer is familiar with the installation of RS485 Communication networks.
The following instructions and procedures are presented at a technical level that assumes familiarity
with networks and local electrical rules and regulations.
Because each network is designed to be configured to its own application requirements and since
each customer's application is dierent, no two sites will be the same. However, the following rules
and information will cover any possible scenarios.
Organisation of this Manual
This instruction manual has six sections:
Chapter
Number
Chapter Title Description
Chapter 1
Common
Requirements
Provides a description of the common network requirements.
Chapter 2 Primary Networks
Provides a description of the primary network and how each
device can be connected to the network and a total overview of
the network requirements.
Chapter 3
Sub Network
Devices
Provides a description of Sub Network Devices and how each
device can be connected to the network and a total overview of
the network requirements.
The two types of sub networks are the Remote Expansion
Modules, (REM’s) and the Sub System Network.
Chapter 4
General Cable
Specifications
Provides a list of the general network rules that apply to all net-
works and the cable specifications.
Chapter 5 Glossary of Terms
The Glossary of Terms is intended to ensure that the contents of
this manual are clear and easily understood by the reader.
The glossary contains simple explanations of the technical terms
used in this manual; explanations are given in non-technical
language where possible.
Chapter 6
Factory Settings for
RS485 End of Line
Termination (EOL)
Provides a table of the Factory Settings for RS485 End of Line
Termination (EOL).
Table 1: Document Organisation