User's Manual

ManualsBrandsInnovative Control Systems ManualsElectronicsRFID Transceiver for use in Patient Egress Monitoring

3-2 The S-TAD User Manual

Activating/Deactivating Tags

The S-TAD can activate and deactivate Tags

preserving Tag battery life and preventing

nuisance alarms.

ACTIVATING

1. Unlock the S-TAD using your unique

4-digit user code.

2. On the back of the S-TAD, place the

inactive Tag in the correct orientation

within the Tag receptacle. On the front

of the S-TAD, the Tag graphic’s LED is

off (just like the physical Tag’s LED is

off).

3. Press the Enter button (green LED lit).

The Wait LED will illuminate (red) for

2 seconds. The Tag graphic’s LED on

the S-TAD will illuminate (pulsing

yellow) indicating the Tag is active (just

like the physical Tag’s LED will

illuminate).

4. If a Low Tag Battery condition is

detected, the Low Tag Battery LED will

illuminate red.

5. If a band alarm condition is detected, the

Band LED will illuminate red.

Likewise, if a band compromise

condition is detected, the Band LED will

illuminate half green and half red.

Note: Band alarm, band compromise,

and cut band conditions always take

precedence over a Low Tag Battery

condition, therefore, be sure to handle

the band-sensing Tag appropriately to

truly check for a Low Tag Battery

condition.

6. The S-TAD will still detect active Tags

and Low Battery conditions in the area

even after the Enter LED extinguishes.

However, you will have to unlock the S-

TAD again to be able to

activate/deactivate a Tag. Remember the

S-TAD will automatically lock after 1

minute of inactivity (by default).

DEACTIVATING

1. Unlock the S-TAD using your unique

4-digit user code.

2. On the back of the S-TAD, place the

active Tag in the correct orientation

within the Tag receptacle. On the front

of the S-TAD, the Tag graphic’s LED

will be pulsing yellow (just like the

physical Tag’s LED will be pulsing).

3. Press the Enter button (green LED lit).

The Wait LED will illuminate (red) for

2 seconds. The Tag graphic’s LED on

the S-TAD will extinguish indicating the

Tag is deactivated (just like the physical

Tag’s LED will extinguish).

Figure 6.9 S-TAD Tag Orientation

- DRAFT -