User Manual

INSTALLATION
MOUNTING
Head mounting kit
ORDERING INFORMATION
LIMITED WARRANTY
APAQ C130
RTD
70C1300011
Head mounting kit 70ADA00017
DIN-rail Adapter + Screw (10 pcs) 70ADA00027
OUTPUT LOAD DIAGRAM
53/2.08
10/0.39
DIN-rail
Adapter
mm/inches
APAQ C130
RTD
is designed to fit inside connection heads type DIN
B or larger. The larger center hole, diameter 7 mm/0.28 inch,
facilitates the pulling through of the sensor leads or an insert tube,
greatly simplifying the mounting procedure.
Connect input, output and power supply acc. to
“CONNECTIONS”. A convinient way to install the transmitter is
to use the INOR mounting kits for in-head and DIN rail mounting.
In order to minimize measuring errors make sure the connecting
screws are tightened enough, 0.5-0.6 Nm.
!
CONNECTIONS
INOR Process AB, or any other aliated company within the Inor Group (hereinafter
jointly referred to as ”Inor”), hereby warrants that the Product will be free from
defects in materials or workmanship for a period of ve (5) years from the date of
delivery (”Limited Warranty”). This Limited Warranty is limited to repair or replace-
ment at Inor’s option and is eective only for the rst end-user of the Product. Upon
receipt of a warranty claim, Inor shall respond within a reasonable time period as to
its decision concerning:
1 Whether Inor acknowledges its responsibility for any asserted defect in
materials or workmanship; and, if so,
2 the appropriate cause of action to be taken (i.e. whether a defective
product should be replaced or repaired by Inor).
This Limited Warranty applies only if the Product:
1 is installed according to the instructions furnished by Inor;
2 is connected to a proper power supply;
3 is not misused or abused; and
4 there is no evidence of tampering, mishandling, neglect, accidental damage,
modication or repair without the approval of Inor or damage done to
the Product by anyone other than Inor.
This Limited Warranty is provided by Inor and contains the only express war-
ranty provided.
INOR SPECIFICALLY DISCLAIMS ANY EXPRESS WARRANTY NOT
PROVIDED HEREIN AND ANY IMPLIED WARRANTY, GUARANTEE
OR REPRESENTATION AS TO SUITABILITY FOR ANY PARTICULAR
PURPOSE, PERFORMANCE, QUALITY AND ABSENCE OF ANY HID-
DEN DEFECTS, AND ANY REMEDY FOR BREACH OF CONTRACT,
WHICH BUT FOR THIS PROVISION, MIGHT ARISE BY IMPLICATION,
OPERATION OF LAW, CUSTOM OF TRADE OR COURSE OF DEALING,
INCLUDING IMPLIED WARRANTIES OF MER-CHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. EXCEPT AS PROVIDED HER-
EIN, INOR FURTHER DISCLAIMS ANY RESPONSIBILITY FOR LOSSES,
EXPENSES, INCONVENIENCES, SPECIAL, DIRECT, SECONDARY OR
CONSEQUENTIAL DAMAGES ARISING FROM OWNERSHIP OR USE
OF THE PRODUCT.
Products that are covered by the Limited Warranty will either be repaired or replaced
at the option of Inor. Customer pays freight to Inor, and Inor will pay the return
freight by post or other “normal” way of transport. If any other type of return freight
is requested, customer pays the whole return cost.
The transmitters are delivered with either a default factory setting or
congured according to customer’s specication.
Maximum load depending on power supply
Formula for the max. permissible output load for APAQ C130
RTD
:
R =(U-6)/0.022
Load
RTD
RTD
RTD
Pt100 / Pt1000
2-wire connection
Pt100 / Pt1000
3-wire connection
Pt100 / Pt1000
4-wire connection
DIMENSIONS
* Short terminals 1 and 2
on the transmitter
*
How to mount on DIN-rail Adapter
Step 1
Step 2