Specifications

February 18, 2020
Page 24/26
Document Ref: isp_ble_DS1807_R9.docx
Insight SiP – Green Side – 400 avenue Roumanille – BP 309 – 06906 Sophia-Antipolis Cedex – France – www.insightsip.com
The information contained in this document is the property of Insight SiP and should not be disclosed to any third party without written permission.
Specification subject to change without notice.
BLE MODULE
ISP1807
OEM Responsibilities to comply with FCC
- The module is limited to OEM installation only.
- The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove
or install module.
- The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is
maintained between the radiator (antenna) and all persons at all times.
- The transmitter module must not be co-located or operating in conjunction with any other antenna or
transmitter except in accordance with FCC multi-transmitter product procedures.
- Separate approval will be required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations other than supplied
antennas.
As long as the condition above is met, further transmitter testing will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.). Also, the OEM integrator is responsible to provide to the host manufacturer for compliance with the
Part 15B requirements.
Host User Manual
The host manual shall include the following regulatory statement:
Part 15.19: This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Part 15.21: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
RF exposure
This device is only authorized for use in a mobile application. This device should be installed
and operated with minimum distance 20cm between the radiator & your body.
Host Product labeling
The module is labeled with its own FCC. If the FCC ID is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. In that case, the final end product must be labeled in a visible area with
the following:
“Contains FCC ID: 2AAQS-ISP1807”
8.4. Canada – User information
This intends to inform how to specify the IC ID of our module “ISP1807” on the product. According to
Canadian standards “RSS-210” and “RSS-Gen”, the host device should have a label which indicates that
it contains our module. The label should use below example wording or any similar wording that
expresses the same meaning: