Specifications

February 18, 2020
Page 25/26
Document Ref: isp_ble_DS1807_R9.docx
Insight SiP – Green Side – 400 avenue Roumanille – BP 309 – 06906 Sophia-Antipolis Cedex – France – www.insightsip.com
The information contained in this document is the property of Insight SiP and should not be disclosed to any third party without written permission.
Specification subject to change without notice.
BLE MODULE
ISP1807
“Contains IC: 11306A-ISP1807”
The label of the host device should also include the below IC Statement. When it is not possible, this
information should be included in the User Manual of the host device:
“This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.”
8.5. RF Exposure Information
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF)Exposure Guidelines in Supplement C toOET65 and RSS-102
of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it
deemed to comply without maximum permissive exposure evaluation (MPE).
8.6. Informations concernant l'exposition aux fréquences radio (RF)
La puissance de sortie émise par l’appareil de sans-fil est inférieure à la limite d'exposition aux
fréquences radio d'Industry Canada (IC). Ce module a également été évalué et démontré conforme aux
limites d'exposition aux RF d'IC dans des conditions d'exposition à des appareils mobiles et/ou
portables.
8.7. Discontinuity
Normally a product will continue to be manufactured as long as all of the following are true:
- The manufacturing method is still available.
- There are no replacement products.
- There is demand for it in the market.
In case of obsolescence, Insight SiP will follow Jedec Standard JSD-48. A Product Discontinuation
Notice (PDN) will be sent to all distributors and made available on our website. After this, the procedure
goes as follows:
- Last Order Date will be 6 months after the PDN was published.
- Last Shipment Date will be 6 months after Last Order Date, i.e. 12 months after PDN.