Quick Start Guide

V6 ENGLISH 20-0236
USING YOUR COOLER
Setting the temperature
Press the Temperature up ( ) or down ( ) buttons, to increase or decrease the
temperature by one degree.
The temperature range is 34° ~ 50° F (1° ~ 10° C).
Press and hold the Temperature up ( ) or down ( ) buttons at the same time for
three seconds to switch between Fahrenheit and Celsius.
If you experience a power outage, your cooler remembers the currently set temperature and
returns to that setting when power is restored.
Using the display
When you plug in your cooler for the rst time, the display screen turns on for three seconds,
and you hear a start-up tone.
In normal mode, the display shows the set temperature.
Lighting your cooler
Press Light ( ) to turn the interior light on or o. The buzzer sounds when the light is
turned on or o.
Entering standby mode
Press and hold Standby ( ) for three seconds. The buzzer sounds and the display turns o.
To return to normal mode, press Standby ( ) again.
Reversing the door
• See the online user guide for steps on reversing the door.
CLEANING YOUR COOLER
1 Turn o your cooler and unplug it from the wall outlet.
2 Remove all beer and beverages.
3 Wash the inside with a damp warm cloth soaked in a solution of one quart of lukewarm
water to two tablespoons of baking soda solution.
4 Be sure to keep the door gasket (seal) clean to keep your cooler running eciently.
5 Dry the interior and exterior with a soft cloth.
TIPS ON SAVING ENERGY
Place your cooler in the coolest area of the room, away from heat producing appliances or
heating ducts and out of the direct sunlight.
Do not overload your cooler because it forces the compressor to run longer.
Do not open the door too often, especially if the weather is hot. Close the door as soon as
possible to prevent cool air from escaping.
Make sure that your cooler is suciently ventilated with adequate air circulation.
SPECIFICATIONS
• Dimensions (H×W×D): 19.4 × 18.9 × 17.3 in. (49.2 × 48 × 44 cm)
• Weight: 50.7 lbs (23 kg)
• Power requirements: 115 V~60 Hz-65 W
• Current: 0.8 A
Cooler temperature range: 34–50 °F (1–10 °C)
WARNING
Electric Shock Hazard
Failure to follow these instructions can result in electric
shock, re, or death.
1 WARNING–Keep ventilation openings in the appliance clear of
obstruction.
2 WARNING–Do not touch the interior of the cooler compartment
with wet hands. This could result in frost bite.
3 WARNING–Do not use mechanical devices or other means to
accelerate the defrosting process, other than those recommended by the manufacturer.
4 WARNING–Do not damage the refrigerant tubing when handling, moving, or using the
appliance.
5 WARNING–Do not use electrical appliances inside the food storage compartment of the
appliance, unless they are of the type recommended by the manufacturer.
6 WARNINGDANGER—Never allow children to play with, operate, or crawl inside the
appliance.
Risk of child entrapment. Before you throw away your old refrigerator or freezer:
1) Take o the doors
2) Leave the shelves in place so that children may not easily climb inside
7 Unplug the appliance before carrying out user maintenance on it.
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer support, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2020 Best Buy. All rights reserved.
TROUBLESHOOTING
Fault indication
If a fault is detected, the display shows one of the following codes:
If either of these error codes appears on the display, contact your local dealer or service center. Do
not try to repair your cooler yourself.
FAULT CODE
DESCRIPTION
E1
Temperature sensor fault
E4
Defrost sensor fault
PROBLEM:
My cooler does not
operate.
The cooler door does not
close completely.
My cooler is not cold
enough.
My cooler makes unusual
noises or vibrates.
Moisture is building up in
the interior of my cooler.
My cooler turns on and o
frequently.
SOLUTION:
Make sure that your cooler is plugged in and that the
plug is pushed completely into the outlet.
Check the house fuse or circuit breaker box and replace
the fuse or reset the circuit breaker.
If a power failure occurs, your cooler turns o. Wait until
the power is restored, then turn it on again.
Adjust the shelf correctly.
Clean the door gaskets.
Level your cooler with the leveling feet.
Make sure that the door is closed correctly.
Allow time for the new beverage to cool, then check
again.
Set the control to a colder setting.
Level your cooler with the leveling feet.
Move your cooler out from the wall.
• This is normal.
Make sure that the door is closed correctly.
Move your cooler to a dryer location.
Cool the room or move your cooler to a cooler location.
Make sure that the door is closed correctly.
Clean the door gaskets.
Set the control to a colder setting.