AV Receiver Instruction Manual

37
First Time Setup —Continued
Crossover
Note:
• If the crossover frequency is set to a low value, and the
program material doesn’t contain any sounds below
that frequency, the subwoofer will not output much
sound.
Subwoofer Mode
With this setting, you can boost bass output by feeding
front left and right channel bass sounds to the subwoofer.
This setting can only be made if the Subwoofer setting in
step 4 is set to Yes, and the Front setting in step 5 is set
to Large.
Note:
• These procedures can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
8
Use the Up and Down [ ]/[ ]
buttons to select “g. Crossover,”
and then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you’re using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you’re not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
Continue with step 9.
9
Use the Up and Down [ ]/[ ]
buttons to select “h. Subwoofer
Mode,” and then use the Left and
Right [ ]/[ ] buttons to select:
LFE only: The subwoofer only outputs
the LFE channel.
Double Bass: In addition to LFE chan-
nel sounds, the subwoofer outputs front
left and right channel bass sounds.
Speaker cone
diameter
Crossover
frequency
Over 8 in.
(20 cm)
60Hz
70Hz
6-1/2 to 8 in.
(16–20 cm)
80Hz
90Hz
5-1/4 to 6-1/2 in.
(13–16 cm)
100Hz
110Hz
3-1/2 to 5-1/4 in.
(9–13 cm)
120Hz
130Hz
Under 3-1/2 in.
(9 cm)
150Hz
200Hz
10
Press the [Setup] button.
Setup closes.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “3. Speaker
Setup,” and then press [Enter].
The Speaker Setup menu appears.
3
Use the Up and Down [ ]/[ ]
buttons to select “Speaker Dis-
tance,” and then press [Enter].
The Speaker Distance menu appears.
Note:
Speakers that you set to No or None on
the Speaker Config menu (page 36)
cannot be selected.
3-2.Speaker Distance
------------------------
a.Unit :feet
b.Front :12.0ft
c.Center :12.0ft
d.Surround R : 7.0ft
e.Surround L : 7.0ft
f.Subwoofer :12.0ft
DTR-4.6.book Page 37 Thursday, September 22, 2005 1:45 PM