Datasheet

56 Datasheet
Intel
®
Celeron
®
Processor up to 1.10 GHz
NOTES:
1. Unless otherwise noted, all guidelines in this table apply to all Celeron processor frequencies.
2. Guidelines are for the edge rate of 0.3 – 0.8 V/ns. See Figure 13 for the generic waveform.
3. All values specified by design characterization.
4. This guideline applies to Intel Celeron processors operating with a 66 MHz system bus only.
5. Ringback below V
REF + 250 mV is not supported.
Table 33. AGTL+ Signal Groups Ringback Tolerance Guidelines for Edge Finger
Measurement on the S.E.P. Package
T# Parameter Min Unit Figure Notes
α
’: Overshoot 100 mV 13
τ’: Minimum Time at High 1.5 ns 13 4
ρ’: Amplitude of Ringback –250 mV 13 4, 5
φ’: Final Settling Voltage 250 mV 13 4
δ’: Duration of Squarewave Ringback N/A ns 13
Figure 13. Low to High AGTL+ Receiver Ringback Tolerance
τ
α
ρ
φ
V
start
V +0.2
REF
V
REF
V –0.2
REF
Time
Clock
Note: High to Low case is analogous.
δ
0.7V Clk Ref