User's Guide

For use in Norway
This product is also designed for an IT power system with phase-to-phase voltage 230V.
Power cord set requirements
WARNING! To reduce the risk of electric shock or damage to the equipment:
● Plug the power cord into an AC outlet that is easily accessible at all times.
● Disconnect power from the computer by unplugging the power cord from the AC outlet.
● If provided with a 3-pin attachment plug on the power cord, plug the cord into a grounded (earthed) 3-
pin outlet. Do not disable the power cord grounding pin, for example, by attaching a 2-pin adapter. The
grounding pin is an important safety feature.
The power cord set received with the product meets the requirements for use in the country where the
equipment was originally purchased. Use only the power cord provided with the unit or an authorized
replacement power cord from HP Inc. or an approved HP Inc. source. Replacement part numbers may be found
at http://www.hp.com/support.
Power cord sets for use in other countries must meet the requirements of the country where you use the
product. For more information on power cord set requirements, contact your authorized HP dealer, reseller,
or service provider.
WARNING! Do not use power cords from other products.
Mismatched power cords may result in a shock and re hazard.
The requirements listed below are applicable to all countries:
1. The power cord must be approved by an acceptable accredited agency responsible for evaluation in the
country where the power cord set will be installed.
2. The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power cord 2.0 m
(6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm
2
or 18AWG. If the power
cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a minimum of 1.0 mm
2
or 16AWG.
The power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
WARNING! Do not operate this product with a damaged power cord set. If the power cord set is damaged in
any manner, replace it immediately. Damaged cords may result in user exposure to hazards.
Power cord notice
If you were not provided with a power cord for the computer or for an external power accessory intended for
use with the computer, you should purchase a power cord that is approved for use in your country or region.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the diameter of the wire must be a minimum of 0.75 mm²/
18AWG, and the length of the cord must be between 1.0 m (3.2 ft) and 2 m (6.56 ft). If you have questions
about the type of power cord to use, contact your authorized service provider.
A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or
against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits
from the product.
Power supply and power cord set requirements 19