Product Data Sheet / Brochure

Intel NUC Board/Kit/Mini PC NUC11TN{X} Technical Product Specification

• HDR (High Dynamic Range) support

• HDCP (High-bandwidth Digital Content Protection) 2.3, 2.2, and 1.4

Notes:

1. Resolution support is subject to memory bandwidth availability

2. Single 8K at 60 Hz display, supported by monitors that accept dual DP input for tiled screen

3. Not available on “Lite” SKUs

3.2.3 Intel® UHD Graphics for 11

Gen Intel Processors

Intel® UHD Graphics for 11

Gen Intel Processors features the following:

• DirectX* 12.1 support

• OpenGL* 4.5 support

• Max HDMI resolution 4096x2304 at 60Hz

• Max DP resolution 7680x4320 at 60Hz

†

• OpenCL* 2.0 support

†

Not available on “Lite” SKUs

3.2.4 Display Emulation

Display emulation is supported using the HDMI ports so that the system may be remotely

accessed in a headless configuration or be capable of tolerating display connectivity interruptions

without the operating system redetecting and rearranging the overall display layout. The display

emulation feature may be enabled in BIOS Setup with the following checkboxes:

• “Virtual display emulation”: provides a 1280x1024 virtual display when no displays are

connected to the system and provides an additional 1280x1024 virtual display if one

display is attached to the system. If two displays are attached to the HDMI ports these

displays will be enabled and no virtual displays will be provided.

• “Persistent display emulation”: emulates that both displays are always connected to the

system no matter their actual connection status. The EDID information from each display

will remain programmed through S3, S4, S5 and G3 power states until the feature is

disabled.

• When “Persistent display emulation” is enabled another drop-down menu

(“Inconsistent Display Device”) will become visible that allows the user to select

the behavior of the system when the display device EDID is inconsistent with the

EDID stored by the system.

▪ “Block boot” (default selection): the BIOS will display a warning message

with options and will wait indefinitely for a user selection.

▪ “Countdown”: the BIOS will display a warning message with options and

will wait 10 seconds before booting.

NOTE

When using “Persistent display emulation” it would be expected behavior for the system not to

properly drive displays different than those connected when the feature was enabled, as the EDID

parameters of the initially connected displays are still being driven by the system. In order to

retrain the system for different displays, the persistent display emulation feature must be disabled