Installation Manual

Attention!

The processor fan heatsink must align properly with the 370-pin socket. Make sure to

align the fan heatsink with the socket base as shown above. This will align the fan

cable with the PGA370 mark on the socket. Note: The Intel

Celeron™ processor at

533 MHz and greater ships with a 3 wire fan.

Intel recommends this processor for motherboards that utilize the 370-pin

socket, and are validated for these processors. Use of this Intel Celeron

processor in some 370-pin socket motherboards or with some “slot-to-

socket”adapters (SSA) may result in processor damage. Contact your

motherboard manufacturer to ensure that your motherboard and SSA have been

validated for use with this specific processor. For more specific information,

please go the World Wide Web as listed below.

http://support.intel.com/support/processors

sockfab3.eps

PGA370

Part Number A02794-002

Second Edition January 2000





Intel Corporation 2000.

*Third-party brands and names are the property of their respective owners.

mendo_flyer_trans_533_ppgafly1_3wire.p65 2/1/00, 5:07 PM1