Network Card User Manual

196 MPCMM0001 Chassis Management Module Software Technical Product Specification
RMCP
20.10 Configuring IPMI Command Privileges
The cmdPrivillege.ini file located in the /etc directory of the CMM allows the configuration of
privileges allowed for each IPMI command on the CMM.
Note: The CMM or cmd_hand must be restarted for the changes to the cmdPrivillege.ini to take effect.
The format of the file is as follows:
[IPMI]
NumNetFunc=23
NetFunc[Net Function1]=[Net Function Name 1]
NetFunc[Net FunctionN]=[Net Function Name N]
[Net Function Name 1]
NumCMD=Y
[Command Byte 1]=[Privelege Level]
[Command Byte Y-1]=[Privelege Level]
Where:
AdvancedTCA™ PICMG 3.0 Spec
Get PICMG Properties
Get Address Info
Get Shelf Address Info
Set Shelf Address Info
FRU Control
Get FRU LED Properties
Get LED Color Capabilities
Set FRU LED State
Get FRU LED State
Set IPMB State
Set FRU Activation Policy
Get FRU Activation Policy
Set FRU Activation
Get Device Locator Record ID
Get Port State
Set Power Level
Get Power Level
Table 89. IPMI Commands Supported by CMM RMCP (Sheet 3 of 3)
Command Type Defined In Command