Network Card User Manual

MPCMM0001 Chassis Management Module Software Technical Product Specification 79
The Command Line Interface (CLI)
The following table shows the values target can be for the CMM location.
Table 22. CMM Targets
Keyword Description
Brd Temp Board Temperature
CPU Temp CPU Temperature
FilterTrayTemp[1,2] Filter Tray Temperature Sensors
CPU Core V CPU Core Voltage
VBAT Battery Voltage
VTT DDR CMM Memory voltage
+2.5V +2.5V voltage sensor
+3.3V +3.3V voltage sensor
+5V +5V voltage sensor
+12V +12V voltage sensor
CDM [1,2] Chassis Data Modules 1 and 2
Air Filter Air Filter
Filter Tray Filter Tray FRU
Filter Run Time Filter Run Time
BIST Built-In Self Test Sensor
FRU Hot Swap FRU Hot Swap sensor
Filter Tray HS Filter Tray Hot Swap sensor
IPMB-0 Snsr [1-16] IPMB 0 sensors
FRU FRU file for CMM
all_leds Target for configuring all user-definable LEDs on the CMM front panel
hsled Hot swap LED on the CMM front panel
userled[1-4] Corresponds to userled A-D on the CMM front panel
feedN
Corresponds to power feed (i.e. feed1, feed2). Use the feedcount
dataitem to determine number of power feeds for component.
PmsGlobal Target for PMS global data
PmsProcN Target for each process monitored where N is the process number
Datasync Status Datasync Status Sensor
CMM Status CMM Status Sensor
PmsPieN Process monitoring process integrity sensors
None Same as not entering a target