Intel X25-V SATA Solid-State Drive Product Line Product Manual

ManualsBrandsIntel ManualsOtherIntel SSD 530 Series

Order Number: 322736-002US

January 2010

Intel

X25-V SATA Solid State Drive

Model Codes: SSDSA2M040G2XX

Product Codes: SSDSA2MP040G2XX

Product Manual

 Available in 2.5” Form Factor

 Capacity: 40 GB

 Uses Intel NAND flash memory Multi-Level Cell

(MLC) components

 Read and Write IOPS Specifications

(Iometer* Queue Depth 32)

— Random 4 KB Reads: Up to 25 K IOPS

— Random 4 KB Writes: Up to 2.5 K IOPS

 Bandwidth Performance Specifications

— Sustained Sequential Read: Up to 170 MB/s

— Sustained Sequential Write: Up to 35 MB/s

 Latency Specifications:

— Read: 65 µs

—Write: 110 µs

 Compatibility

—Intel

SSD ToolBox

Intel

SSD Optimizer

—Intel

Matrix Storage Manager

— SATA Revision 2.6 compliant, compatible

with SATA 1.5 Gb/s and 3 Gb/s interface

rates

— ATA/ATAPI-7 Compliant

— SSD Enhanced S.M.A.R.T. ATA feature set

— Native Command Queuing (NCQ) command

set

 Certifications and Declarations

—UL*

—CE*

—C-Tick*

—BSMI*

—KCC*

—Microsoft* WHQL

—VCCI*

—SATA-IO*

 Power Management

— 5 V (2.5”) SATA Supply Rail

— SATA Interface Power Management

— OS-Aware Hot Plug/Removal

 Power Specifications

— Active: 150 mW (TYP)

(MobileMark* 2007 Workload)

— Idle: 75 mW (TYP)

 Temperature

—Operating: 0

C to 70

— Non-Operating: -55

C to 95

 Reliability

— Read Error Rate (BER):

1 sector per 10

bits read

— Mean Time Between Failures (MTBF):

1,200,000 hours

 Shock, Operating and Non-operating:

1,500 G/0.5 msec

 Vibration

— Operating: 2.17 GRMS (5-700 Hz)

— Non-operating: 3.13 GRMS (5-800 Hz)

 Weight: 68 +/-2 grams

 Data Set Management Command

— Trim Attribute

 Product Ecological Compliance

—EU RoHS*

—Halogen-free

—

Summary of content (24 pages)

PAGE 1
Intel® X25-V SATA Solid State Drive Model Codes: SSDSA2M040G2XX Product Codes: SSDSA2MP040G2XX Product Manual         Available in 2.5” Form Factor Capacity: 40 GB Uses Intel NAND flash memory Multi-Level Cell (MLC) components Read and Write IOPS Specifications (Iometer* Queue Depth 32) — Random 4 KB Reads: Up to 25 K IOPS — Random 4 KB Writes: Up to 2.
PAGE 2
Ordering Information L For ordering information on Intel® Solid State Drives please refer to the Intel® High Performance SATA Solid-State Drives Product Selection Guide. INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL® PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT.
PAGE 3
Intel® X25-V SATA SSD Contents 1.0 Introduction ............................................................................................................. 1.1 Product Overview ............................................................................................... 1.2 Block Diagram.................................................................................................... 1.3 Architecture ....................................................................................................
PAGE 4
Intel® X25-V SATA SSD Intel® X25-V SATA Solid State Drive Product Manual 4 January 2010 Order Number: 322736-002US
PAGE 5
Intel® X25-V SATA SSD 1.0 Introduction The Intel® X25-V SATA Solid State Drive (SSD) delivers capacity and optimized performance for cost sensitive and rugged platforms in the industry standard 2.5” form factor. By combining Intel’s leading 34nm NAND flash memory technology with our innovative high performance controller, Intel delivers its SSD for native Serial Advanced Technology Attachment (SATA) hard disk drive drop-in replacement with enhanced performance, reliability, ruggedness and power savings.
PAGE 6
Intel® X25-V SATA SSD 1.2 Block Diagram Figure 1. Block Diagram NAND Flash Memory Flash Memory Channel 0 SATA Interface Intel System On A Chip (SOC) Flash Memory Channel ... NAND Flash Memory NAND Flash Memory Flash Memory Channel n 1.3 Architecture The Intel X25-V SATA SSDs utilize a cost effective System on a Chip (SOC) design to manage a full SATA 3 Gb/s bandwidth with the host while managing multiple flash memory devices on multiple channels internally. 2.
PAGE 7
Intel® X25-V SATA SSD Table 1. Device Certifications and Declarations Certification Description KCC Compliance with paragraph 1 of Article 11 of the Electromagnetic Compatibility control Regulation and meet the Electromagnetic Compatibility (EMC) Framework requirements of the Radio Research Laboratory (RRL) Ministry of Information and Communication Republic of Korea.
PAGE 8
Intel® X25-V SATA SSD Table 4. Latency Specifications Type Average Latency Read 65 µs (TYP) Write 110 µs (TYP) Power On to Ready 1.50 s (TYP) Notes: 1. 2. 3. 4. Write Cache Enabled. Device measured using Iometer. Power On To Ready time is measured from power rail rising edge to the first DRDY issued from the drive. Read/Write latency measured on sequential 4 K transfers with QD=1. Table 5.
PAGE 9
Intel® X25-V SATA SSD 3.4 Environmental Conditions 3.4.1 Temperature Table 8. Temperature Related Specifications Mode Case Temperature Temperature Gradient Humidity Min Operating Non-Operating Typ Max Unit 0 70 o C -55 95 o C Operating 20 oC/hr Non-Operating 30 o * C/hr * Operating 5 95 % Non-Operating 5 95 % Notes: 1. Temperature measured on the top side of SSD case, centered for width and one inch from SATA connector edge. 2.
PAGE 10
Intel® X25-V SATA SSD 3.4.4 Electromagnetic Immunity Electromagnetic Immunity tests assume the SSD is properly installed in the representative host system. The drive will operate properly without errors or degradation in performance when subjected to radio frequency (RF) environments referenced in the international specifications noted in these following documents: Table 10.
PAGE 11
Intel® X25-V SATA SSD 3.5.1 Nonrecoverable Read Errors The nonrecoverable read error rate will not exceed one sector in the specified number of bits read. In the extremely unlikely event of a nonrecoverable read error, the drive will report it as a read failure to the host; the sector in error is considered corrupt and is not returned to the host. 3.5.
PAGE 12
Intel® X25-V SATA SSD Figure 2. Note: Dimensions for Intel X25-V SATA SSD 2.5” 9.5 mm Form Factor All dimensions are in millimeters.
PAGE 13
Intel® X25-V SATA SSD 5.0 Pin and Signal Descriptions This section identifies the pin locations and signal descriptions of the Intel X25-V SATA SSDs. 5.1 Pin Locations Figure 3. Layout of Signal and Power Segment Pins Signal Segment S1 Note: Power Segment P1 2.5” connector supports inbuilt latching capability. 5.2 Signal Description Table Table 12.
PAGE 14
Intel® X25-V SATA SSD Table 13. Serial ATA Power Pin Definitions Pin1 Function P1 Not connected 2 (3.3 V Power) P2 Not connected2 (3.3 V Power) P3 Not connected 2 P4 Ground3, 4 1st Mate P5 Ground3 1st Mate P6 Ground3 1st Mate P7 V53, 5 5 V Power 1st Mate P8 V53, 5 5 V Power 2nd Mate P9 V53, 5 5 V Power 2nd Mate P10 Ground3 Definition (3.3 V Power. pre-charge) Mating Order 2nd Mate 1st Mate P11 DAS6 P12 Ground3, 4 P13 V127 12 V Power. Not used.
PAGE 15
Intel® X25-V SATA SSD 6.1.
PAGE 16
Intel® X25-V SATA SSD 6.1.1.1 IDENTIFY DEVICE Data The following table details the sector data returned after issuing an IDENTIFY DEVICE command. Table 14.
PAGE 17
Intel® X25-V SATA SSD Table 14. Word Returned Sector Data (Continued) F = Fixed V = Variable X = Both Default Value Description 75 F 001Fh Queue depth 76 F 0506h Serial ATA capabilities 77 F 0h 78 F 0048h Serial ATA features supported 79 V 0040h Serial ATA features enabled 80 F 00FCh Major Version Number 81 F 001Ah Minor Version Number 82 F 746Bh Command set supported. 83 F 7D01h Command sets supported. 84 F 6163h Command set/feature supported extension.
PAGE 18
Intel® X25-V SATA SSD Table 14.
PAGE 19
Intel® X25-V SATA SSD 6.1.3 Security Mode Feature Set The Intel X25-V SATA SSD supports the Security Mode command set, which consists of • SECURITY SET PASSWORD • SECURITY UNLOCK • SECURITY ERASE PREPARE • SECURITY ERASE UNIT • SECURITY FREEZE LOCK • SECURITY DISABLE PASSWORD 6.1.
PAGE 20
Intel® X25-V SATA SSD 6.1.7 48-Bit Address Command Set The Intel X25-V SATA SSDs support the 48-bit Address command set, which consists of • FLUSH CACHE EXT • READ DMA EXT • READ NATIVE MAX ADDRESS EXT • READ SECTOR(S) EXT • READ VERIFY SECTOR(S) EXT • SET MAX ADDRESS EXT • WRITE DMA EXT • WRITE MULTIPLE EXT • WRITE SECTOR(S) EXT • WRITE UNCORRECTABLE EXT 6.1.
PAGE 21
Intel® X25-V SATA SSD 6.2.2 Native Command Queuing The Intel X25-V SATA SSDs support the Native Command Queuing (NCQ) command set, which includes • READ FPDMA QUEUED • WRITE FPDMA QUEUED Note: 6.2.3 With a maximum queue depth equal to 32. Device Initiated Power Management (DIPM) The Intel X25-V SATA SSDs support the SET FEATURES parameter to enable Device Initiated Power Management. 7.0 References This document references standards defined by a variety of organizations.
PAGE 22
Intel® X25-V SATA SSD Table 15. Standards References (Continued) Date or Rev. # Title April 2004 1995 1996 1995 1995 1997 1994 1995 8.0 Location ATA-7 Volume 1 http://www.t13.org/Documents/UploadedDocuments/ docs2007/D1532v1r4bAT_Attachment_with_Packet_Interface__7_Volume_1.
PAGE 23
Intel® X25-V SATA SSD Table 17. Glossary of Terms and Acronyms (Continued) Term Definition Device Initiated Link Power Management (DIPM) The ability of the device to request SATA link power state changes. DIPM Device Initiated Power Management (SATA hard disk drive) DMA Direct Memory Access DRAM Dynamic Random Access Memory EXT Extended FP First Party GB Giga-byte defined as 1x109 bytes.
PAGE 24
Intel® X25-V SATA SSD Table 17. Glossary of Terms and Acronyms (Continued) Term Definition TBD To Be Determined VCCI Voluntary Control Council for Interface WHQL Microsoft* Windows Hardware Quality Labs Write Cache A memory device within a hard drive, which is allocated for the temporary storage of data before that data is copied to its permanent storage location. 10.