User Manual

IS-SNAKE DevKit Setup Manual
 2014 Nintendo 11 CTR-XX-XXXX-XXX-X
CONFIDENTIAL Released: August 7, 2014
5.5 Attaching the Ferrite Cores
Follow the procedure below to attach the ferrite cores.
Attach a ferrite core to the USB cable.
Loop the cable through the core twice as
shown in the figure, leaving about 5
centimeters or 2 inches from the USB-B
connector.
Attach a ferrite core to the AC adapter
cord.
Loop the cable through the core once as
shown in the figure, leaving about 5
centimeters or 2 inches from the DC
connector.
When using the debug controller, also
attach ferrite cores to the controller cable.
Connect the cores as shown in the figure.
Starting from the connector, leave a gap of
5 centimeters or 2 inches, then attach the
first small ferrite core with two loops of
cord. Next attach the large ferrite core,
again with two loops of cord. Lastly, attach
the second small ferrite core close to the
controller, with just one loop of cord.