User Manual

IS-SNAKE DevKit Setup Manual
 2014 Nintendo 15 CTR-XX-XXXX-XXX-X
CONFIDENTIAL Released: August 7, 2014
7. To use the IS-CTR-CAPTURE
software, insert a USB cable into the
CAPTURE TESTER USB port on the
back panel of the IS-SNAKE-BOX.
8. Connect the DC plug of the AC
Adapter to the DC connector (DC IN)
on the rear panel of IS-SNAKE-BOX.
9. Plug the AC adapter into a standard
120 V AC wall socket.
5.9 Turning the Power On and Off
Follow the procedure below to turn the power on.
1. Turn on the power switch on the rear of the IS-SNAKE-BOX.
2. The PWR and SYS LEDs on the front of the IS-SNAKE-BOX turn on as follows.
a) The PWR LED briefly turns red.
b) The PWR and SYS LEDs both turn green.
c) The SYS LED turns off.