User Manual

IS-SNAKE DevKit Setup Manual
CTR-XX-XXXX-XXX-X 16  2014 Nintendo
Released: August 7, 2014 CONFIDENTIAL
3. If the power LED on the controller turns on and the LCD screen shows an image, the device can be
used.
Follow the procedure below to turn the power off.
1. Turn off the power switch on the rear of the IS-SNAKE-BOX.
The controller will turn off automatically. This does not require any separate operation.
5.10 Activating the License
After installing batteries for the first time or replacing them, use the following procedure to activate your
license. You will not be able to use the features of the software unless you configure these settings.
1. Connect the IS-SNAKE-BOX hardware to a computer.
2. Turn on the power of the IS-SNAKE-BOX.
3. From the Start menu, select IS-CTR-XXX > IS-CTR-XXX to launch the software.
4. If ISUpdate automatic updates are enabled, the software is automatically activated on startup.
5. If activation is successful, no messages or other notifications will appear. Continue to use the
software.
If you see a message indicating that the license must be activated, follow the instructions in the
message. This involves connecting to the Internet and activating the license.
Contact support if you do not have an Internet connection available.