User Manual

IS-SNAKE DevKit Setup Manual
 2014 Nintendo 7 CTR-XX-XXXX-XXX-X
CONFIDENTIAL Released: August 7, 2014
3 Notes
Read the following items carefully to use the IS-SNAKE DevKit unit safely and ensure the unit does not
malfunction and possibly cause a safety hazard.
 Do not turn off the IS-SNAKE-BOX during firmware updates. The IS-SNAKE-BOX may not function
properly afterward.
 After turning off the power, do not immediately turn it back on again. The IS-SNAKE-BOX may not
function properly afterward. After turning off the power, wait at least 10 seconds before turning it on
again.
 The liquid crystal display on the controller may develop pixels that are always illuminated or that do
not illuminate. Also, you might observe irregularity in color or brightness, depending on the angle of
view. These are properties of the liquid crystal display and are not defects.
 Note that we do not guarantee that video can be captured without dropping any frames. Some
frames may be dropped, depending on your computer environment.
 Be aware of possible rights infringement when using audio or video captured using IS-SNAKE
DevKit, such as copyright or portrait rights. Note that Nintendo accepts absolutely no responsibility in
the event that copyright, portrait rights, or any other rights have been infringed, or a third party’s
privacy, character, or reputation has been damaged by the distributing, copying, or modifying of
captured audio or video.
 Use AA alkaline batteries. Use of any other type of battery may result in leakage or other problems
that could damage the device.
 Promptly replace the batteries after they have been used up.
 Follow the battery disposal guidelines for your area of residence when discarding used batteries.
 The ground line must be no longer than 3 meters.
 Use the included USB cables for USB connections.
 We recommend using a Nintendo Genuine HDMI cable (WUP-008).