user manual

73
Destination
The destination can be specified as the IP address of a
subnet or a specific host in the subnet. It can also be
specified as all zeros to indicate the route should be used
for all destinations for which no other route is defined
(this is the route that creates the default gateway).
Subnet Mask
The network mask of the destination subnet. The default
gateway uses a mask of 0.0.0.0.
Next Hop
The IP address of the next hop through which traffic will
flow toward the destination subnet.
Metric
Defines the number of hops between network nodes that
data packets travel. The default value is 0, which means
that the subnet is directly one hop away on the local LAN
network.
Interface
The WAN interface to which a static routing subnet is to
be applied.
Show Routes
Click to view the router’s routing table.
Static Route Table
Click “Update” to update the selected destination route in
the Static Route Table. Click “Delete Selected” to delete
a selected destination route in the table.
When you finish, click “Apply Changes.” You’ll see the following message
displayed on Web browser.
Click “Continue” to save the settings made and go back to the Web management
interface; click “Apply” to save the settings made and restart the router so the
settings will take effect after it reboots.