Installation Manual User guide

Chapter 2
40 Concord Express Installation Instructions
High Level Rpts (0121-pager 1, 0131-pager 2, 0141-
pager 3)
Phones-Pager Phone 1-3
(Default=on)
When this setting is on, the panel reports to the pager
events that involve a high-level security risk, including
the following conditions:
• Fire, Police, Auxiliary, Duress, and Freeze alarms
• No Activity
• Receiver Failure (or jam)
• System Tamper (40 incorrect keystrokes or
touchpad supervisory),
• Entering or exiting Sensor Test mode
To turn High-Level Reports off or on:
1. With the display showing HIGH
LEVEL RPTS OFF/ON (current
setting), press 1 (off) or 2 (on). The
display flashes the entered setting.
2. Press # and the display shows the
new setting.
Low Level Rpts (0122-pager 1, 0132-pager 2, 0142-
pager 3)
Phones-Pager Phone 1-3
(Default=off)
When this setting is on, the panel reports non-alarm
conditions to the pager, including the following conditions:
• Force Armed
• Hardwire Zone Trouble (open or short)
• Supervisory (wireless devices)
• Low Battery (wireless devices)
• Other non-alarm related conditions
To turn Low-Level Reports off or
on:
1. With the display showing LOW
LEVEL RPTS OFF/ON (current
setting), press 1 (off) or 2 (on).
The display flashes the entered
setting.
2. Press # and the display shows
LOW LEVEL RPTS OFF/ON (new
setting).
Open/Close Rpts (0123-pager 1, 0133-
pager 2, 0143-pager 3)
Phones-Pager Phone 1-3 (Default=off)
When this setting is on, the panel sends a
report when the system is armed (closed)
or disarmed (opened).
Note: To use this feature, the Opening
Reports and Closing Reports settings
under the REPORTING menu must be
turned on.
To turn Opening/Closing Reports off or on:
1. With the display showing OPEN/CLOSE RPTS
OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.