Installation Manual User guide

Chapter 2
54 Concord Express Installation Instructions
Closing Reports (0511)
Reporting-Partition 1 (Default=off)
This setting determines whether or not
the panel sends a closing report to the
central station (or pager) after arming the
system.
Note: To use this feature, the
Open/Close Reports settings under the
PHONES—CS PHONE 1-2 and/or
PHONES—PAGER PHONE 1-3 menus
must be turned on for the specific CS
Phone or Pager Phone number..
To turn Closing Reports off or on:
1. With the display showing CLOSING REPORTS
OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.
Recent Closings (0512)
Reporting-Partition 1 (Default=on)
This setting determines whether or not
the panel sends a recent closing report to
the central station (or a pager) if an alarm
occurs within two minutes after the exit
delay time expires. Such a report is used
to identify a possible exit fault.
To turn Recent Closings off or on:
1. With the display showing RECENT CLOSINGS
OFF/ON (current setting), press 1 (off) or 2 (on).
The display flashes the entered setting.
2. Press # and the display shows the new setting.
No Activity (0513)
Reporting-Partition 1 (Default=off)
This setting determines whether or not
the panel sends a no activity report to the
central station (or pager) if there is no
system activity within a preset time
period.
To turn No Activity reports off or on:
1. With the display showing NO ACTIVITY OFF/ON
(current setting), press 1 (off) or 2 (on). The
display flashes the entered setting.
2. Press # and the display shows the new setting.
Duress Option (0514)
Reporting-Partition 1 (Default=off)
This setting determines whether or not the
system can be controlled using a programmed
duress code.
Caution: Because using duress codes often
results in false alarms due to code entry errors, it
is strongly recommended not to program any
duress codes. If a duress code is absolutely
necessary, their use with an Interrogator is highly
recommended to reduce false alarms and
accidental dispatches.
To turn Duress Option off or on:
1. With the display showing DURESS
OFF/ON (current setting), press 1 (off) or 2
(on). The display flashes the entered
setting.
2. Press # and display shows the new setting.