Installation Manual User guide

Chapter 2
Concord Express Installation Instructions 61
Unit-ID (0800 thru 0803)
Acc. Modules-Bus Devices (Default=none)
This menu lets you identify all
connected bus devices, each device
address, unit ID number, and other
configurations based on a specific
device. You can also delete learned
bus device addresses.
Note: To help identify bus devices,
the 8-digit unit ID number is also
located on a label on each SuperBus
2000 device.
To identify bus device Unit and ID:
1. With the display showing BUS DEVICES, press #. The
display shows the bus device unit number and the 8-digit
unit ID number. For example, UNIT - ID 0—02110185.
Where 0 is the bus device unit number and 02110185 is
the unit ID number.
2. Press A or B to identify all other bus device unit numbers
(0-3) and identification numbers.
To delete learned bus device unit numbers:
1. With the display showing BUS DEVICES, press #. The
display shows the bus device set to unit number 0.
2. Press A or B until the bus device unit number you want
to delete is displayed.
3. Press D. The display changes the unit number to NONE.
Device ID
Acc. Modules-Bus Devices (Default=none)
This menu lets you change a
bus device ID number when
replacing a defective bus
device.
To change a Device ID:
1. With the display showing the desired device, press # twice. The
display shows DEVICE ID (current ID).
2. Enter the ID of the new bus device. The display flashes the
entered selection. Press # and the display shows the new
setting.
3. Exit programming mode.
4. Remove AC and battery power from the panel.
5. Replace the defective bus device with the new one.
6. Apply AC and battery power to the panel.
Status Beeps
Acc. Modules-Bus Devices (Default=on)
This setting determines whether or not the
selected touchpad sounds status beeps. Each
touchpad can be set individually. This feature is
usually turned off if a touchpad is located in or
near bedrooms to avoid disturbing persons
sleeping.
Note: For UL Listed systems, Status Beeps must
be turned on.
To turn touchpad Status Beeps on or off:
1. With the display showing the desired
touchpad, press # then B once. The display
shows TOUCHPAD OPTIONS.
2. Press # and the display shows STATUS
BEEPS OFF/ON (current setting).
3. Press 1 (off) or 2 (on) to select the desired
setting. The display flashes the entered
selection. Press # and the display shows the
new setting.