Installation Manual User guide

Chapter 2
Concord Express Installation Instructions 65
To enter user-programming mode:
Press 9 + CODE. The display shows TIME AND DATE. Press
Time and Date Menu
The TIME AND DATE menu lets you set the panel clock and calendar.
Alphanumeric touchpads display the time and date whenever the system is
disarmed. Setting the time and date is important for accurate tracking of system
events stored in the event buffer. The panel uses a global clock and calendar for
time and date.
The following describes how to set the panel time and date.
Time (00)
Time and Date (Default=00:00)
This setting lets you adjust the
panel clock to the correct time. The
panel uses a 24-hour clock,
eliminating the need to designate
A.M. or P.M. For example, to set the
time to 4:17 P.M., enter 1617.
To set the Time:
1. With the display showing TIME AND DATE, press # and
the display shows TIME hh:mm AM/PM (current time).
2. Enter the correct time (0000 - 2359). The display flashes
the entered time. Press # and the display shows the new
time.
Date (01)
Time and Date (Default=01/01/00)
This setting lets you adjust the
panel calendar to the correct
month, day, and year.
To set the Date:
1. With the display showing TIME AND DATE, press # then
B and the display shows DATE nn/nn/nn (current date).
2. Enter the correct month (01 - 12), day (01 - 31), and year
(00 - 99). For example, enter 090100 for September 1,
2000. The display flashes the entered date. Press # and
the display shows the new date.
User Codes Menu
Important: Each security access code (Installer, Dealer, system Master, or User)
must be unique. Do not use the same combination of numbers for any two codes.
The USER CODES menu lets you program/change regular user access codes
and the system master code.