Installation Manual User guide

Chapter 3
72 Concord Express Installation Instructions
Basic system commands
Table 4 below describes the basic system touchpad operating commands. For
complete details on system operation, including user programming, refer to the
system users guide.
Table 4: Basic system commands
Command
Response
* (STATUS)
Indicates current system status
1 + CODE
Disarms system to OFF
2 + CODE
Arms system to STAY
3 + CODE
Arms system to AWAY
2 (quick arm on)
Arms system to STAY
3 (quick arm on)
Arms system to AWAY
2 or 3 + CODE + 4
or
2 or 3 + 4
Makes entry/exit doors instant (4 must be pressed within five seconds
of arming)
5 + 2 or 3 + CODE
or
5 + 2 or 3
Arms system silently (no arming status beeps)
7 + 1
Turns chime feature on and off
7 + 6
Identifies alarms in memory
8 + CODE + 2
Initiates a phone test
8 + CODE + 3
Initiates a sensor test
8 + installer CODE + 3
Initiates a dealer sensor test
Testing Zones/Sensors
We recommend that you test sensors/zones after all programming is completed
and whenever a zone/sensor-related problem occurs.
If the system does not respond as described in the following procedure, see the
“Troubleshooting” section.
Note: While the sensor test is a valuable installation and service tool, it only tests
sensor operation for the current conditions. You should perform a sensor test
after any change in environment, equipment, or programming.
1. Place all sensors/zones in their non-alarm state.
2. At an alphanumeric touchpad, enter the sensor test mode by pressing 8 +
installer CODE + 3. The touchpad sounds one beep and displays SENSOR
TEST, 15 MINUTES LEFT. The system stays in sensor test for 15 minutes.