User Manual

Concord Express User Instructions 25
Assigning the System Test Attribute
System Tests is a user code attribute that allows the user to perform system
tests. If the user code does not have this attribute turned on, the user will not be
able to perform phone or sensor tests.
To assign the System Testing to a user:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 10 n n 2 where nn is user 00 through 15.
3. To turn System Testing:
on, press 2 + #.
off, press 1 + #.
4. Press * + 4 + # to exit the programming menus.
The Touchpad Tamper Feature
The installer can program your system to send a Police alarm in the case of
possible touchpad tampering.
If more than 40 keys are pressed when the system asks for a code, and those
keystrokes are not part of a valid access code, a siren will sound. See “Touchpad
Information” on page 42 to determine if this feature is enabled for your system.
Setting the Time and Date
Although the installer usually sets the time and date at the time of installation, the
user can change it when necessary. See “Appendix C: Programming Your
System” on page 50 for more detailed information on setting this feature.
To set the system time:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 00.
3. Enter the correct time in 24-hour format (4 digits), then press #.
For example, if the current time is 7:23 a.m., press 0723 + #.
4. Press * + 4 + # to exit the programming menus.