User Manual

28 Concord Express User Instructions
2 + # Medium
3 + # High
4. Press * + 4 + # to exit the programming menus.
After dimming the display, pressing any button momentarily returns the display to
full brightness. After 15 seconds without touchpad activity, the display returns to
the set dimmed level. If an alarm occurs while the display is dimmed, it
automatically returns to the full brightness level and stays that way until you
disarm your system.
Notification by Pager
Your system can notify up to three different pager phone numbers to report
system events. The installer can program any pager to receive pages for one or
more of the following groups:
• High Level Reports, which includes the following reports:
– Sensor alarms – Bus failures
– Sensor Tamper – No activity alarm
– Sensor Restores – Fire panic
– Phone test – Police panic
– Receiver failure – Auxiliary panic
– Receiver jam – Duress alarm
– Touchpad tamper
• Low Level Reports, which includes the following reports:
– Bypass sensors –AC power fail
– Sensor Low battery – CPU low battery
– Sensor Supervisory – Auto phone test
– Sensor Trouble – CPU back in service
– Phone test – Phone Failure
– Touchpad supervisory – Event buffer full
– Touchpad low battery
– Force armed (reports when a user bypasses sensors while arming
system)
• Opening and Closing reports
• Latchkey Paging
Pager Messages
When an event is reported on a numeric pager, the following information is
included: