User Manual

-------------------------------------- DRAFT COPY --------------------------------------

Instructions for Model HA09 – Handy Remote Controller

User’s Manual

*Illustration of HA09 controller*

General Description

Federal Communications Commission Statement

This device complies with part 15 of the FCC rules. Operation of this device is subject to

the following two conditions: (1) This device may not cause harmful interference, and

(2) This device must accept any interference, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

-- Reorient or relocate the receiving antenna or device.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

WARNING!

Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

Enclosed you will find:

1 Handy Remote Controller

Installation Instructions

Remote Controller

1. Open the battery compartment located on the back of the remote controller by

pressing down on the battery compartment tab and pulling the door outward.

2. Insert 4 “AAA” alkaline batteries (not included) with polarities as shown.

3. Replace the battery compartment by first inserting the 2 tabs at the bottom of the

door, then pressing the door in until the door ‘clicks’ shut.

PAGE 1
-------------------------------------- DRAFT COPY -------------------------------------Instructions for Model HA09 – Handy Remote Controller User’s Manual *Illustration of HA09 controller* General Description Federal Communications Commission Statement This device complies with part 15 of the FCC rules.
PAGE 2
Z-wave Compatible Module: 1. Install a Z-wave compatible module as described by its instruction manual. 2. Do not exceed the maximum ratings of the module. Operating Instructions Creating a Network 1. On the remote controller, the include button is located behind a protective sliding door. Slide the door down to gain access to the Include and Exclude buttons. 2. Press and release the include button. The green LED will begin to flash indicating that the controller is ready to register modules. 3.
PAGE 3
Uses 4 size “AAA” alkaline batteries. 1.5VDC ea. Suitable for use in dry locations. This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation.