Manual
- The remaining material is now automatically fed into
the cutting mechanism again and shredded.
- The control display
of the forwards button (3) is permanently lit.
- When the material has run through, continue
shredding with correct quantities.
forwards and backwards alternately until the material
has completely run through and has been shredded.
Wait each time until the motor stops
before switching direction!
display
rocker switch (1).
After a cooling down period of approx. 25-40 minutes
(depending on the model and room temperature), you
can switch the machine on again.
(Auto-reverse function)
machine reacts as follows:
in reverse (material is released) and stops. The
motor is switched off.
- The control display (6) lights up.
Proceed as follows:
Paper jam in paper feed slot (12)
- Remove released paper from the feed slot (12).
and shreds the remaining paper in the cutting
mechanism.
- The control display
of the forwards button (3) is permanently lit.
- Remove released material.
Take care when removing material as
sharp edges may cause injury!
points:
- is the mains plug
- is the machine in
- has the user interlock
- is the receptacle
- is the receptacle
- is there a material jam
If none of the above applies, please contact your
26SC2
26CC3
32SC2
32CC3
16
89894 8 03/13
7
GB
after a certain operating time.
(7) lights up, proceed
as follows:
Pull out receptacle (14), take oil receptacle (16) (Fig.
6) out of the holder in the lower cabinet and push
receptacle in again.
it into the cutting mechanism through the paper feed
slot (12).
The paper is drawn in and the oil thus gets into the
cutting mechanism.
- Pull out receptacle (14) until the control display
(8) lights up.
- The control displays (7) and
- Press backwards button (4) and keep pressed until
the control display (7) goes out.
- Push receptacle in again.
guide (for example after a paper jam) it is possible
that the machine will not turn off, due to the broken
light barrier.
To remove these paper strips and also to clean the
photocell, pass another sheet of paper through the
feed slot, or switch the machine to reverse and wipe
The cutting mechanism now automatically begins
the cleaning cycle (forwards operation/backwards
operation) and then switches off. The machine is
of the function button
switched on, it must be deactivated again when the
OPERATING THE
MACHINE
Dispose of the machine in an environmentally
friendly fashion at the end of its useful service
life. Do not dispose of any of the parts
included in the machine or its packaging with
household waste.
*
TECHNICAL DATA
SPECIAL ACCESSORIES
Description
Plastic bag, 300x300x700x0.018 mm 99925
Lubricant, 110 ml bottle 88035
For orders of special accessories and spare parts,
please contact your dealer.
Pre-fusing (slow-blow): 220-240V = 10 amps / 120V = 15 amps
Intermittent operation
Dimensions Weight
intimus 26SC2
intimus 26CC3
intimus 32SC2
intimus 32CC3
supply voltage/frequency · current consumption · power
intimus 26SC2
intimus 26CC3
intimus 32SC2
intimus 32CC3