Installation and User's Guide Network Adapter

Page 50 of 83
Verifying Correct Installation
Use this procedure to verify installation of your ITI-8000 Series Ultra2 SCSI
adapter before booting your system:
1 Power on the system.
2 When the banner is displayed, press the Stop-A keys to
interrupt the boot process and stop at the ok prompt.
3 Use the show-devs command to list the system devices. You
should see an output similar to the following:
/SUNW,UltraSPARC-IIi@0,0
/pci@1f,0
/virtual-memory
/memory@0,0
/packages
/pci@1f,0/pci@1
/pci@1f,0/pci@1,1
/pci@1f,0/pci@1/pci@1
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1/tape
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1/disk
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0/tape
/pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0/disk
/pci@1f,0/pci@1,1/network@3,1
/pci@1f,0/pci@1,1/scsi@2
/pci@1f,0/pci@1,1/network@1,1
/pci@1f,0/pci@1,1/ebus@1
ok
• /pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0
identifies the FIRST SCSI interface on an IntraServer ITI-
8000 Series adapter
• /pci@1f,0/pci@1/pci@1/IntraServer,Ultra2-scsi@0,1
identifies the SECOND SCSI interface on the IntraServer ITI-
8000 Series adapter
Note: The above are examples. The output of show-devs will vary
depending on your system and configuration. Use the
corresponding entries on your system, not the ones given here.
If these devices are not listed, check that the adapter is correctly installed, and
re-seat the adapter if necessary.