Installation and User's Guide Network Adapter

Page 59 of 83
intra # cat /etc/hostname.qfe3
intra-4
Create an appropriate entry in the /etc/hosts file for each active qfe channel.
intra # cat /etc/hosts
…
127.0.0.1 localhost
192.168.120.10 intra loghost
192.168.121.10 intra-1
192.168.122.10 intra-2
192.168.123.10 intra-3
192.168.124.10 intra-4
Reboot your system
Booting from the Network Using Solaris
You can use the qfe driver on your ITI-8241C-S adapter to boot over the
network using the following example:
Find the hme device from the ok prompt:
ok show-devs
Find the full name of the hme you want to boot, for example:
/pci@1f,0/pci@1/pci@2/IntraServer,qfe@0,1
/pci@1f,0/pci@1/pci@2/IntraServer,qfe@1,1
/pci@1f,0/pci@1/pci@2/IntraServer,qfe@2,1
/pci@1f,0/pci@1/pci@2/IntraServer,qfe@3,1
Note: You need to select only one of these qfe devices for booting
Start the boot:
ok boot /pci@1f,0/pci@1/pci@2/IntraServer,qfe@0,1