Operation Manual

7.1.1 Status Display

NOTE:

The ON/OFF diode is used as a fault display (status display). Chapter "Error Codes and

Diagnostic Codes" on page 42 contains an explanation of the error codes.

7.1.2 Battery Charge Display

• All diodes illuminate: maximum driving range

• Only red and yellow diodes illuminate: reduced driving range. Recharge the batteries at the

end of your journey.

• Only red LEDs illuminate/blink, electronics beeps 3x: battery reserve = severely

restricted driving range. Recharge batteries immediately!

NOTE:

Overdischarge protection: after a certain drive time on reserve battery power the electronics

system switches the drive off automatically and brings the Scooter to a standstill. If you do not

drive your Scooter for a while the batteries will "recuperate" and allow a further, but short,

journey. However, after a very brief journey the red diodes will illuminate again and the electronic

system will beep three times. This procedure leads to battery damage and should be avoided if

possible!