Operation Manual

34
7.2 Driving the Scooter
WARNING: Danger from the unintended rolling of the vehicle!
When stopping the vehicle, the drive lever needs to return entirely to the middle position
to activate the electromagnetic brakes. If there is any obstruction stopping the lever from
returning to the middle position, the electromagnetic brakes cannot be activated. This can
lead to the vehicle rolling unintentionally.
• Please make sure that the drive lever is in the middle position, if the vehicle is to remain
stationary.
• Switch the power supply on (keyswitch) The operating console display illuminates. The Scooter
is ready to drive.
NOTE:
If the Scooter is not ready to drive after switching on, check the status display (see Chapter
"Status Display" on page 33 and Chapter "Diagnosis and fault repair" on page 40.
• Set the required speed with the speed controller.
• Pull the right-hand drive lever carefully to travel forwards.
• Pull the left-hand drive lever carefully to travel in reverse.
NOTE:
The control system is programmed with standard values in the works. Your Invacare®dealer can
carry out programming tailored to fit your requirements.