User Manual

10. WATER TANK & DRAIN HOSE

There are two ways to remove collected water. Before proceeding ensure that you have

switched o and unplugged the unit.

1. Usage of the water tank

When unit is OFF and the tank of the dehumidier is full, the full indicator will be lit.

Additionally, when the unit is on and the tank is full, indicator will illuminate, and the unit

will automatically stop operating.

• Carefully remove the bucket. Slowly slide the water tank outwards to the accumulated

water does not overow.

• Lift the plastic lid, in order to remove the accumulated water from the tank, once the

water is emptied close the plastic lid once again, and place the tank securely and properly

into the device.

• When the water tank is re-installed the unit will automatically restart.

• When you remove the tank, do not touch any parts inside

the unit, as you may damage the device.

• Be sure to gently place the tank into the dehumidier.

• Do not drink or use the collected water from the device.

• Wipe any excess water on, or in, the unit when removing

the tank.

2. Continuous draining

Water automatically can be emptied into a oor drain by

attaching the unit with a water hose.

• Remove the rubber plug located opposite the unit.

Insert the water hose into the drain outlet and make sure

all connections are rmly tightened in order to avoid any

possible leaks.

• The dehumidier - air purier, should be placed on a at

surface in an upright position.

• Lead the water hose towards a suitable drainage facility

and be certain that the water ows naturally. For correct

drainage, make sure the hose stays below the level of the

drain hose outlet.

water drain

hose outlet