User Manual

25
EN
The unit does not start
l Make sure the dehumidier’s plug is placed completely into the socket.
l Check the house fuse/circuit breaker box.
l Check whether the power cord is damaged.
l Check the water bucket, if it is full, empty it.
l Check if the dehumidier has reached its preset level.
l Make sure the water bucket is positioned properly.
l Room temperature is lower or higher than the advised operational range.
l Check whether the humidity level has been set in high levels.
Dehumidier does not dry the air as ecient
l Make sure that the dehumidier has been operating enough time to remove the
moisture.
l Make sure there are no curtains, blinds or furniture blocking the front or back of the
dehumidier.
l The humidity selector may not be set low enough.
l Make sure you have cleaned the lter as suggested. Clogged lter may result in reduced
performance.
l All house exits (windows doors etc) where the dehumidier is operating, should be shut.
l Room temperature is below the advised operational range.
l There is a kerosene heater or something giving o water vapor in the room.
l The room that the device is placed is bigger than suggested.
l The humidity level is too high.
The unit makes a loud noise when operating
l The air lter is clogged.
l The device is tilted instead of being in an upright position.
l The oor surface is not at.
Frost build up on coils
l This is normal. This unit is supplied with an Auto defrost feature.
Drain hose water leakage
l Check the correct installation of the drain hose.
l Check for any blockage or damage of the drain hose.
Understanding Error code indications
C1 - Temperature humidity sensor or NTC failure
C2 - Temperature sensor failure
C8 - Refrigerant leakage or NTC ≥40°C