User Manual

5
EN
l If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualied persons to avoid a hazard. Never attempt to dismantle, repair or modify
the device.
l Do not attempt to repair, dismantle or modify this appliance. Contact your authorized
service technician for repair or maintenance of this device.
l Do not operate or stop the unit by switching the power supply on or o.
l Do not insert any objects in the unit’s air inlet and exhaust as this may cause damage to the
device.
l Do not place heavy objects on the power cord. Make sure that the cord is not compressed.
l Do not place cord under any obstacles (carpets rugs or runners etc). Cord should be
arranged away from areas where accidental tripping may occur.
l Casters should be able to move comfortably over any obstacle. Be extra cautious while
moving over carpets, since any extra force may cause the tipping of the unit, or the spilling of
any water collected in the bucket.
l Do not sit or climb on the device.
l Do not place the unit in direct sunlight or near other heating sources.
l Do not use the unit near heat sources, chemicals, radiators, ammable materials or re.
l Do not remove the water tank while the device is in use.
l Do not use the device without the lter. Dirt and lint may clog the unit thus reducing
performance.
l Do not drink or use the collected water of the unit for any purpose.
l Do not use the unit with wet hands.
Upon rst use, and for proper calibration, please
allow unit to operate continuously for 24 hours.
UV-C lamp
This appliance contains a UV-C lamp. Read the maintenance instructions before opening the appliance.
1. Do not operate UV-C lamps outside of the appliance.
2. Appliances that are obviously damaged must not be operated.
3. Unintended use of the appliance or damage to the housing may result in the escape of dangerous UV-C radiation.
UV-C radiation may, even in small doses, cause harm to the eyes and skin.
4. Before opening doors and access panels bearing the ULTRAVIOLET RADIATION hazard symbol for the conducting
USER MAINTENANCE, it is recommended to disconnect the power.
5. The UV-C lamp cannot be cleaned, repaired and replaced.
6. UV-C BARRIERS bearing the ULTRAVIOLET RADIATION hazard symbol should not be removed.