User Manual

Note:
Clean filters make sure that your appliance functions correctly.
1. Remove the lower basket.
2. Turn the main filter (A) counter-clockwise to remove it.
Note:
The micro filter is attached to the main filter.
3. Remove the main filter (A) from the micro filter (B).
4. Remove the sieve (C).
5. Clean the main filter, the micro filter and the sieve. Use warm water and a dishwasing brush.
6. Install the sieve.
7. Install the main filter into the micro filter. Make sure that the markers are aligned.
8. Install the main filter into the sieve.
9. Turn the main filter clockwise to fasten it.
Caution:
Make sure that the filters are placed correctly. Incorrect placement of the filters affects the maximum
performance of the appliance.
CLEANING THE SPRAY ARMS
1. Remove the upper and lower basket.
2. Remove the nut (A).
3. Remove the upper spray arm (B).
4. Pull the lower spray arm (C) upwards to remove it.
5. Clean the spray arms. Use warm water.
6. Install the lower spray arm (C).
7. Install the upper spray arm (B).
8. Tighten the nut (A).
DRAINING THE PUMP
Food residue or foreign objects that were not captured by the filters can cause the waste water pump to block. The
rinsing water level will be above the filter. Drain the pump to remove the blockage.
Warning:
Broken glass or sharp objects can cause injuries.
1. Make sure that the appliance is disconnected.
2. Remove the lower basket.
3. Remove the filters. Refer to setion
'Cleaning the filters' .
4. Remove the excess water. Use a sponge or cloth.
5. Remove the blockage.
6. Install the filters.
(Figure 25)
(Figure 26)
(Figure 27)
(Figure 28)
(Figure 29)
(Figure 30)
52 • English